All Products

This is basicly a **12mm socket nut with thin wall** and 120mm extension with 8mm inbus needed for some forks to work on the deep inside foot nut.👀

Oil and Dust Seal Kit for 38mm Marzocchi forks.

You can close the canti post using this screw if you go disc. Works for all older Marzocchis 1989 - 1996.

Height 83mm

This package is about parts you need to SERVICE your Marzocchi 32mm with 2x SEAL-Kit classic & 2 Tools🎈🎁🛠💊 ✨✨ Buy this Package for your 32mm Marzocchi Fork and save about 30%!! ✨✨  

SPRINGS KIT K=5,0/DJ 2004

full compatible 24mm Oil Seal Press-In Tool for all 24mm Marzocchi Forks

SLEEVE

This tool is used for pressing the 38mm oil seal into the lowers top. The smaler bottom section is long enough to keep the tool vertical as this is most impoartant to press the oil seal in! You can also use it to press the dust seal in, but take that little outer ring spring out of the dust seal before you do!!

Original SHIVER DC cartridge, used. Good condition. Incl. C-clip and o-rings.

This is about a HQ Bushings-Kit for 40mm Marzocchi MONSTER’s 1999-2006, custom made with best tolerances! Including the very rare ones with outer PTFE! This are NOT standard Moto bushings.👊 You can select out of 2 versions: Standard Kit (4 pcs : 2 upper + 2 lower bushings) Extended Kit (5 pcs : Standard Kit + 1 Piston Bushings) There is a special product bundle for MONSTER's available : SEALS & BUSHINGS(!!) with a big DISCOUNT!

How to mount? Best is to use minimal screw glue on the both screws type middle hard! This are very small threads, so use minimal torque to screw in.

538111 - Bushings up - gliding layer outside 538110 - Bushings down - gliding layer inside

Marzocchi Bomber Lower Rebound Knob 66/888 red (2011-2018) (1 pcs)

Marzocchi 380 Preload knob – 549266 (2016+) (1 pcs) incl. bits. Check the logo lasering : this is some piece of fine art!

red NUT M8 x 0,75 CH10

This product is about 1 pcs Marzocchi Standard Foot Nut 5321387. It has an O-Ring in the top inside – O-Rings included!!

This tool is used for pressing the 38mm oil seal into the lowers top. The smaler bottom section is long enough to keep the tool vertical as this is most impoartant to press the oil seal in! You can also use it to press the dust seal in, but take that little outer ring spring out of the dust seal before you do!!

Well known Disc Adapter for all early Z1 & Z2 1996+ with Formular (FS) Disc Mounts. This adapter maps standard FS to standard IS and was built for the well known Magura Disc Brake or Hope disc brakes.

RESERVOIR PLUG UNIT Marzocchi lid with expansion nipple for Roco barrel

This product is about 1 pcs Marzocchi Standard Foot Nut 5321395 in black for many 66 & 888. Discount starts with >=2 pcs!